Transfer Case

WARNING: This page is about a different car, the 2021 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

Remove the reverse check sleeve assembly. Ref. to MANUAL TRANSMISSION AND DIFFERENTIAL (5MT)>REVERSE CHECK SLEEVE>REMOVAL .
Remove the oil guide.

Courtesy of SUBARU OF AMERICA, INC.
Remove the oil seal.
Set ST1, ST2 and the transfer case to a press.
NOTE:
- Set the ST2 under ST1.
- Set the transfer case so that the hole for shifter arm is positioned vertically.
Preparation tool:

ST1: CYLINDER HEAD TABLE (498267300)

ST2: CYLINDER HEAD TABLE (498267200)

Courtesy of SUBARU OF AMERICA, INC.
Remove the roller bearing by using a round bar of 22 mm (0.87 in) or 23 mm (0.91 in).

Courtesy of SUBARU OF AMERICA, INC.