LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Manual Transaxle & Differential (5MT)) >> Front Differential Assembly >> Inspection >> HYPOID Driven Gear Backlash

HYPOID Driven Gear Backlash

WARNING: This page is about a different car, the 2021 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the ST, a dial gauge and a magnet stand, check the backlash by inserting the dial gauge through the drain plug hole.

    Preparation tool: 

    ST: PLATE (498255400)

    G13604396Courtesy of SUBARU OF AMERICA, INC.
  2. Install SUBARU genuine axle shafts to both sides, rotate in the inversion direction so that the gauge contacts the tooth surface, and read the dial gauge.
    NOTE: If the backlash is outside the specified range, adjust it by turning the differential side retainer RH.

    Specification: 

    0.13 - 0.18 mm (0.0051 - 0.0071 in)

    Part No. 38415AA100 Axle shaft 

scientia non olet · About LEMON Manuals