LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Engine Starting System & Charging System (HEV) >> Battery >> Installation

Engine Starting System & Charging System (HEV): Battery: Installation

CAUTION:
  • If the battery terminal is worn and the terminal section is loose, replace it with a new battery.
  • Since the initial diagnosis of the electronic throttle control is conducted after the battery terminal is connected, wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.
  1. Install the battery.
  2. Install the battery holder.

    Tightening torque: 

    3.5 N.m (0.4 kgf-m, 2.6 ft-lb)

  3. Install the battery cable holder.
  4. Connect the battery positive terminal.

    Tightening torque: 

    6 N.m (0.6 kgf-m, 4.4 ft-lb)

  5. Connect the battery ground terminal. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals