LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> SUBARU Eyesight System (Driver Assist) (Diagnostics) (HEV) >> Diagnostics With Phenomenon >> Inspection >> Cruise Control Is Not Released After Shifting The Shifting Lever To The Neutral Position

Cruise Control Is Not Released After Shifting The Shifting Lever To The Neutral Position

  1. PERFORM REAL TIME DIAGNOSIS  .

    Check the input signal of cruise control system. Ref. to EYESIGHT (DIAGNOSTICS) (HEV)>REAL-TIME DIAGNOSIS .

    Is the check result OK?

    Yes:  The circuit has returned to a normal condition at this time.

    NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

    No:  Go to  2.

  2. CHECK NEUTRAL POSITION SWITCH  .

    Check the neutral position switch. Ref. to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC P0705-62: TRANSMISSION RANGE SENSOR "A" CIRCUIT (PRNDL INPUT) SIGNAL COMPARE FAILURE .

    Is the check result OK?

    Yes:  Go to  3.

    No:  Repair or replace the faulty portion according to the inspection result.

  3. CHECK STEREO CAMERA POWER SUPPLY VOLTAGE  .

    Check the stereo camera power supply voltage. Ref. to EYESIGHT (DIAGNOSTICS) (HEV)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC B2814: POWER SUPPLY LOW VOLTAGE .

    Is the check result OK?

    Yes:  Replace the stereo camera. Ref. to EYESIGHT>STEREO CAMERA>REMOVAL .

    No:  Repair or replace the faulty portion according to the inspection result.

scientia non olet · About LEMON Manuals