LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Ascent Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> SUBARU Eyesight System (Driver Assist) (Diagnostics) >> Diagnostics with Phenomenon >> Inspection >> Cruise Control Is Not Released After Shifting The Shifting Lever To The Neutral Position

Cruise Control Is Not Released After Shifting The Shifting Lever To The Neutral Position

  1. PERFORM REAL TIME DIAGNOSIS  .

    Check the input signal of cruise control system. Ref. to EYESIGHT (DIAGNOSTICS)>REAL-TIME DIAGNOSIS .

    Is the check result OK?

    Yes  : The circuit has returned to a normal condition at this time.

    NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

    No  : Go to  2.

  2. CHECK NEUTRAL POSITION SWITCH  .

    Check the neutral position switch. Ref. to EYESIGHT (DIAGNOSTICS)>Diagnostic Procedure with ECU Cancel Code>12 . Ref. to EYESIGHT (DIAGNOSTICS)>Diagnostic Procedure with ECU Cancel Code>62 .

    Is the check result OK?

    Yes  : Replace the ECM. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>Engine Control Module (ECM)>REMOVAL

    No  : Repair or replace the faulty portion according to the inspection result.