Multi-function Display (MFD): Installation
CAUTION:
- Make sure the electrical connector is connected securely.
- Make sure that the multi-function display operates normally.
- After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.
- When the multi-function display has been replaced, perform the following operations.
- Be sure to reset the ODO fuel economy value of the multi-function display (MFD). Refer to INSTRUMENTATION/DRIVER INFO>MULTI-FUNCTION DISPLAY (MFD) SYSTEM>OPERATION>ODO FUEL ECONOMY VALUE RESET .
- Be sure to correction the lifetime fuel economy value of the multi-function display (MFD). Refer to INSTRUMENTATION/DRIVER INFO>MULTI-FUNCTION DISPLAY (MFD) SYSTEM>OPERATION>DIAGNOSTIC MODE .
- Install the multi-function display.
- Install the cover center UPR.
- Install the center grille assembly.
- Connect the battery ground terminal. Refer to NOTE>NOTE>BATTERY .