LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> WRX Limited, Standard Trans >> Labor Times >> Other Variant >> Brakes >> Mechanical - Hydraulic >> Brake Shoes &/Or Pads >> Remove & Replace

Brake Shoes &/Or Pads: Remove & Replace

WARNING: This page is about the WRX Base, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies ToNoteStandard HoursWarranty HoursSkill Level
All1.8B
Front or Rear,Both Sides1.0B
Combination Procedure: BRAKE HOSE: Replace:
Includes: Bleed System.
Each Additional0.2B
One0.7B
Combination Procedure: BRAKE SYSTEM: Bleed:
NOTE: This operation is not to be used with any other operation(s) containing brake fluid bleed.
0.6B
Combination Procedure: CALIPER: Replace:
OneIncludes: Bleed Brakes.0.7B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
0.5B
Combination Procedure: DISC ROTOR: Correct:
Lateral Runout,EachCorrect Rotor lateral runout by indexing or correction plate.0.2B
Combination Procedure: DISC ROTOR: Remove & Install or Remove & Replace:
Each0.1B
Combination Procedure: DISC ROTOR (REMOVED): Refinish:
DOES NOT include grind hot spots.
Each Additional0.3B
One0.5B
Combination Procedure: ELECTRONIC PARKING BRAKE SYSTEM: Disable & Enable:
Maintenance ModeIncludes: Disable and enable electronic brake system with use of scan tool or interactive vehicle controls.0.2B
Combination Procedure: HUB & ROTOR DISC: Clean & Inspect:
Corrosion,EachClean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor.0.2B
Combination Procedure: PARKING BRAKE SHOE & LINING: Replace:
Each Side0.4B
Combination Procedure: WHEEL BEARING: Replace:
Each0.4B