LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Outback Onyx Edition XT >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim & Interior Trim >> Console Box >> Removal

Console Box: Removal

  1. Disconnect the ground terminal from battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
    NOTE:
    • Release the shift lock and shift the select lever to the "N" position. Refer to CONTROL SYSTEMS>Select Lever>REMOVAL .
    • On power seat models, move the front seat all the way forward before disconnecting the ground terminal from the battery sensor.
  2. Remove the grip and boot. Refer to CONTROL SYSTEMS>Select Lever>REMOVAL .
  3. Remove the cover assembly front.
    1. Release the clips, and detach the cover assembly front.
      G13625977Courtesy of SUBARU OF AMERICA, INC.
    2. Disconnect the harness connector.
  4. Remove the console box assembly.
    1. Remove the cap console and bolts.
    2. Remove the screws and release the clip.
    3. Disconnect the harness connector, and remove the console box assembly.
      • Model without CD deck
        G13625978Courtesy of SUBARU OF AMERICA, INC.
      • Model with CD deck
        G13625979Courtesy of SUBARU OF AMERICA, INC.
  5. Disassemble the cover assembly front and the console box assembly as required.
scientia non olet · About LEMON Manuals