LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Outback Limited XT >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Intake System (Induction) And Turbocharger (2.4L) >> Intake Duct >> Removal >> Intake Duct No. 1

Intake Duct No. 1

  1. Disconnect the ground terminal from battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the under cover front. Refer to EXTERIOR/INTERIOR TRIM>Front Under Cover>REMOVAL .
  3. Drain engine coolant. Refer to COOLING (H4DOTC)>Engine Coolant>REPLACEMENT>DRAINING OF ENGINE COOLANT .
  4. Disconnect the air intake boot from the air intake duct No. 1.
    G13619978Courtesy of SUBARU OF AMERICA, INC.
  5. Release the lock by sliding the spring, and disconnect the PCV pipe assembly from the intake duct No. 1.
    G13619989Courtesy of SUBARU OF AMERICA, INC.
  6. Disconnect the vacuum hose and the water hose.
    G13619990Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the intake duct No. 1.
    G13619991Courtesy of SUBARU OF AMERICA, INC.
  8. Disconnect the water hose from the intake duct No. 1.
    NOTE: Perform this procedure only when required.
    G13619992Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals