LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag System (Service Information) >> Driver's Airbag Module >> Removal

Driver's Airbag Module: Removal

CAUTION: Before handling the airbag system components, refer to AIRBAG SYSTEM>General Description>CAUTION .
  1. Position the front wheels straight ahead.
  2. Turn the ignition switch to OFF.
  3. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Refer to REPAIR CONTENTS>NOTE>BATTERY .
  4. Remove the driver's airbag module.
    1. Using a hexagon wrench etc. wrapped by protective tape, insert the snap pins and release the locks (three locations).
      G11245794Courtesy of SUBARU OF AMERICA, INC.
    2. Disconnect the horn harness and airbag connector, and remove the driver's airbag module. Refer to AIRBAG SYSTEM>Airbag Connector>PROCEDURE>DRIVER'S AIRBAG MODULE, FRONT SEAT BELT PRETENSIONER AND CURTAIN AIRBAG MODULE .
      G11245795Courtesy of SUBARU OF AMERICA, INC.
      G13622665Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals