LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis >> Electrical >> Gauges >> Driver Monitor (Diagnostics) >> Diagnostics with Phenomenon >> Inspection >> Operation Indicator Light Does Not Switch To Off Indicator Light Even After Pressing The Driver Monitoring System Off Switch

Operation Indicator Light Does Not Switch To Off Indicator Light Even After Pressing The Driver Monitoring System Off Switch

CAUTION: Before performing diagnosis, refer to "CAUTION" in "General Description". Refer to DRIVER MONITORS (DIAGNOSTICS)>GENERAL DESCRIPTION>CAUTION .
  1. CHECK CENTER INFORMATION DISPLAY  .

    Check if the touch sensor on the center information display is functioning properly.

    Is the check result OK?

    Yes  : Go to  2.

    No  : Perform the diagnosis for cockpit control system. Refer to COCKPIT CONTROL (DIAGNOSTICS)>Basic Diagnostic Procedure>PROCEDURE .

  2. CHECK COCKPIT CONTROL MODULE  .

    Check if the GUI changes properly when the Driver Monitoring System OFF Switch in the center information display is changed.

    Is the check result OK?

    Yes  : Go to  3.

    No  : Perform the diagnosis for cockpit control system. Refer to COCKPIT CONTROL (DIAGNOSTICS)>Basic Diagnostic Procedure>PROCEDURE .

  3. CHECK Driver Monitoring Unit  .

    Perform the user re-recognition of Driver Monitoring System in the center information display. Is the recognition possible?

    Yes  : The system has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

    No  : Perform the diagnosis for Driver Monitoring Unit, and if any fault is found, replace the Driver Monitoring Unit. Refer to INSTRUMENTATION/DRIVER INFO>DRIVER MONITORING UNIT .