Parking Brake Actuator
CAUTION:
- Do not remove the parking brake actuator except when there are system malfunctions (such as emergency release of parking brake or abnormal actuator) or when the caliper is replaced. When the parking brake actuator is reused, always replace the O-ring with a new part contained in the caliper body.
- Do not reuse the parking brake actuator when the emergency release of parking brake was performed, or when the parking brake actuator has a malfunction. Always replace with a new parking brake actuator.
- Install the parking brake actuator.
Preparation tool:
Hexagon wrench: 5 mm (0.2 in)
Tightening torque:
8 N.m (0.8 kgf-m, 5.9 ft-lb)
- Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
- Using the Subaru Select Monitor, exit the brake maintenance mode. Refer to PARKING BRAKE>Parking Brake System>OPERATION>BRAKE MAINTENANCE MODE .
- After the operation is completed, apply and release the parking brake five times and ensure that the brake operates normally.
- Install the rear wheels.
Tightening torque:
120 N.m (12.2 kgf-m, 88.5 ft-lb)