LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation System & Driver Information Center (Service Information) >> Switches and Harness >> Removal >> Illumination Control Switch

Illumination Control Switch

  1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Refer to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the cover LWR driver. Refer to EXTERIOR/INTERIOR TRIM>Instrument Panel Lower Cover>REMOVAL .
  3. Release the claws and remove the illumination control switch (b).
    G13625465Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals