DTC B1509: Cockpit Control Signal Input

DTC detecting condition: 

LVDS communication with the cockpit control module is impossible.

Trouble symptom: 

Meter LCD cannot be displayed.

1. CHECK DTC  .
   1. Using the Subaru Select Monitor, perform the clear memory of [Cockpit Control]. Refer to COMMON (DIAG)>CLEAR MEMORY .
   2. Turn the ignition switch OFF - ON.
   3. Read the DTC of [Cockpit Control] using the Subaru Select Monitor. Refer to COCKPIT CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

   Is DTC B1509 displayed? (Current malfunction)

   Yes  : Go to  2.

   No  : Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

   NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
2. CHECK CONNECTOR  .

   Check the harness between the cockpit control module connector and the combination meter.

   Is the check result OK?

   Yes  : Go to  3.

   No  : Repair the harness or replace the components.

3. CHECK COCKPIT CONTROL MODULE  .

   Perform the inspection according to the diagnosis for the cockpit control module. Refer to COCKPIT CONTROL (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE .

   Is the check result OK?

   Yes  : Replace the combination meter. Refer to INSTRUMENTATION/DRIVER INFO>COMBINATION METER .

   No  : Replace the cockpit control module. Refer to ENTERTAINMENT & MONITORING>COCKPIT DISPLAY .