Inspection Using Can Diagnostic

Trouble causes:

Improper body integrated unit setting

CAUTION: Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to LAN SYSTEM (DIAGNOSTICS)>GENERAL DESCRIPTION>CAUTION .

CHECK BODY INTEGRATED UNIT REGISTRATION STATUS.
Check that settings of body integrated unit correspond to vehicle equipment. Ref. to BODY CONTROL (DIAGNOSTICS)>REGISTRATION BODY INTEGRATED UNIT .

Does the vehicle equipment correspond to settings?

Yes: Go to 2.

No: Match the settings of the body integrated unit with the vehicle equipment.
CHECK BODY INTEGRATED UNIT CUSTOMIZE SETTING.
Check that settings of body integrated unit correspond to vehicle condition. Ref. to BODY CONTROL (DIAGNOSTICS)>CUSTOMIZE .

Do the customize settings correspond to the vehicle condition?

Yes: Go to 3.

No: Match the settings of the body integrated unit with the vehicle condition.
CHECK FACTORY INITIAL SETTING OF BODY INTEGRATED UNIT.
Confirm [Factory initial setting] of body integrated unit registrations is [Market]. Ref. to BODY CONTROL (DIAGNOSTICS)>REGISTRATION BODY INTEGRATED UNIT .

Is it set to [Market]?

Yes: Go to step 4 in the Basic Diagnostic Procedure. Ref. to LAN SYSTEM (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .

No: Switch from [Factory] to [Market].