LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Forester Limited >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim & Interior Trim >> Console Box >> Removal

Console Box: Removal

  1. Disconnect the ground terminal from battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
    NOTE:
    • Release the shift lock and shift the select lever to the "N" position. Refer to CONTROL SYSTEMS>SELECT LEVER>REMOVAL .
    • On power seat models, move the front seat all the way forward before disconnecting the ground terminal from the battery sensor.
  2. Attach the protective tape (a) to the cover center side.
    G13227091Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the cover assembly front.
    CAUTION:
    • For models with smart keyless access with push button start, the interior antenna is installed behind cover assembly front. Be careful not to damage the harness when removing the cover assembly front.
    1. Remove the select lever knob.
      G13227092Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the mat center tray.
      G13227093Courtesy of SUBARU OF AMERICA, INC.
    3. Remove the tray center LWR.
      G13227094Courtesy of SUBARU OF AMERICA, INC.
    4. Release the clips, and detach the cover assembly front.
      G13227095Courtesy of SUBARU OF AMERICA, INC.
    5. Disconnect the harness connector.
  4. Remove the console box assembly.
    1. Remove the cap console and remove the bolts.
    2. Remove the screws and release the clip.
    3. Disconnect the harness connector, and remove the console box assembly.
    G13227096Courtesy of SUBARU OF AMERICA, INC.
  5. Disassemble the cover assembly front and the console box assembly as required.
scientia non olet · About LEMON Manuals