Secondary Pressure Sensor: Removal

WARNING: This page is about a different variant/trim than selected.

CAUTION:

Vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.
If CVTF spills over the engine, completely wipe it off to avoid emission of smoke and causing a fire.
If water or oil contacts the connector terminal of secondary pressure sensor, replace it with a new part.

Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
Remove the front exhaust pipe. Ref. to EXHAUST (H4DO (EXCEPT FOR HEV))>FRONT EXHAUST PIPE>REMOVAL .
Disconnect the connector and remove the secondary pressure sensor.

NOTE: Prepare the container for draining of engine oil.

Courtesy of SUBARU OF AMERICA, INC.