LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (CVT Transaxle (Tr580 CROSSTREK)) >> CVTF Cooler (With Warmer Function) >> Installation

CVTF Cooler (With Warmer Function): Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION: If CVTF and engine coolant is spilt over the exhaust pipe, completely wipe it off to avoid emission of smoke or causing a fire.
  1. Install the water hose (inlet).
    G13224722Courtesy of SUBARU OF AMERICA, INC.
  2. Attach a new O-ring to the CVTF cooler (with warmer feature).
  3. Install the CVTF cooler (with warmer feature).
    CAUTION: Be careful not to allow any foreign materials to enter the CVTF cooler (with warmer feature) and the transmission body during installation.

    Tightening torque: 

    19 N.m (1.9 kgf-m, 14.0 ft-lb)

  4. Connect the CVTF cooler hose and the water hose.
    1. Install a new CVTF cooler hose.
      G13603271Courtesy of SUBARU OF AMERICA, INC.
    2. Connect the water hose (inlet) and water hose (outlet).
      G13603270Courtesy of SUBARU OF AMERICA, INC.
    3. Connect the CVTF cooler hose.
    G13603269Courtesy of SUBARU OF AMERICA, INC.
  5. Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO (EXCEPT FOR HEV))>AIR INTAKE BOOT>INSTALLATION .
  6. Fill engine coolant. Ref. to COOLING (H4DO (EXCEPT FOR HEV))>ENGINE COOLANT>REPLACEMENT .
  7. Check the CVTF level. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580 CROSSTREK)>CVTF>INSPECTION .
scientia non olet · About LEMON Manuals