Execution Condition
WARNING: This page is about a different variant/trim than selected.
| Secondary parameters | Execution condition |
|---|---|
| 12 V battery system voltage | 10 V or more |
| Engine speed | 1000 rpm or more |
| Transmission range | Drive |
| Engine torque | Exceeds N-m values in Table 1 |
| Commanded duty of torque converter clutch pressure control | 0% or less solenoid |
ENGINE COOLANT TEMPERATURE SPECIFICATION
| Engine coolant temperature (degC) | |||||||||
| - 40 | - 20 | 0 | 20 | 40 | 60 | 80 | 100 | ||
| Vehicle speed (calculated from measured secondary pulley shaft speed sensor) (MPH) | 0 | 170 | 170 | 170 | 170 | 170 | 170 | 113 | 113 |
| 13 | 170 | 170 | 170 | 170 | 170 | 170 | 142 | 142 | |
| 25 | 170 | 170 | 170 | 170 | 170 | 170 | 150 | 150 | |
| 38 | 170 | 170 | 170 | 170 | 170 | 170 | 170 | 170 | |
| 50 | 170 | 170 | 170 | 170 | 170 | 170 | 170 | 170 | |