Execution Condition

WARNING: This page is about a different variant/trim than selected.

Secondary parameters	Execution condition
Phase 1
12 V battery system voltage	10 V or more
Engine speed	At or more than rpm values in Table 1
Phase 2
Fail detected (P1867)	TRUE
12 V battery system voltage	10 V or more
Ignition state	OFF
Measured primary pulley shaft speed	400 rpm or less
Transmission fluid temperature	5 degC or more

TARGET LINE PRESSURE SPECIFICATION

		Target line pressure (kPa)
		0	500	1000	1500	2000	3000	4000	5000	6000
Transmission fluid temperature (degC)	-40	500	500	500	500	500	500	574	8000	8000
	-20	500	500	500	500	500	500	574	8000	8000
	0	500	500	500	500	500	500	574	8000	8000
	20	500	500	500	500	500	500	574	8000	8000
	40	500	500	500	526	558	626	745	8000	8000
	60	500	515	554	592	629	703	816	8000	8000
	80	516	611	658	705	751	841	1273	8000	8000
	100	598	694	751	806	861	967	1966	8000	8000
	120	684	789	858	921	980	1245	3553	8000	8000