Diagnostic Method

WARNING: This page is about a different variant/trim than selected.

If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.

JUDGMENT VALUE SPECIFICATION

Malfunction Criteria

Threshold Value

Phase 1
ABS⁽¹⁾ (Target pulley pressure - Measured pulley pressure)

More than 500 kPa

Phase 2
Measured pulley pressure sensor input voltage
(Measured pulley pressure)
Measured pulley pressure sensor input voltage
(Measured pulley pressure)

NOTE: Both Phase 1 and Phase 2 must be met to fail the diagnostics.

0.801 V or less
(570 kPa or less)
0.1953 V or more
(0 kPa or more)

⁽¹⁾	ABS: Absolute value

Time needed for diagnosis:

Phase 1 : 5 s
Phase 2 : 3 s

Malfunction indicator light illumination : Illuminates when malfunction occurs in 2 continuous driving cycles.