Hill Hold Indicator Does Not Illuminate

WARNING: This page is about a different variant/trim than selected.

Trouble causes:

CAN communication failure
Combination meter malfunction
Hill hold indicator light circuit malfunction

CAUTION: Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to LAN SYSTEM (DIAGNOSTICS) (HEV)>GENERAL DESCRIPTION>CAUTION .

CHECK DTC .
Read the DTC of [Brake Control] using the Subaru Select Monitor. Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .

Are any DTCs displayed? (Current malfunction)

Yes : Perform the diagnosis for the displayed DTCs.

No : Go to 2.
CHECK DTC .
1. Start the engine.
2. Using the Subaru Select Monitor, read all DTCs. Ref. to LAN SYSTEM (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .
Is DTC U**** displayed? (Current malfunction)

Yes : Perform the diagnosis according to the basic diagnostic procedure in LAN SYSTEM (DIAGNOSTICS). Ref. to LAN SYSTEM (DIAGNOSTICS) (HEV)>BASIC DIAGNOSTIC PROCEDURE .

No : Check the hill hold indicator light. Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>Warning Light Illumination Pattern .