Door Indicator Is Not Displayed

Trouble causes: 

• CAN communication failure
• Body integrated unit malfunction
• Combination meter malfunction
• Door switch circuit malfunction

1. CHECK DTC  .

   Read the DTC of [Body Control] using the Subaru Select Monitor. Ref. to BODY CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

   Are any DTCs displayed? (Current malfunction)

   Yes  : Perform the diagnosis for the displayed DTCs.

   No  : Go to  2.

2. CHECK DTC  .
   1. Start the engine.
   2. Using the Subaru Select Monitor, read all DTCs. Ref. to LAN SYSTEM (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .

   Is DTC U**** displayed? (Current malfunction)

   Yes  : Perform the diagnosis according to the basic diagnostic procedure in LAN SYSTEM (DIAGNOSTICS). Ref. to LAN SYSTEM (DIAGNOSTICS) (HEV)>BASIC DIAGNOSTIC PROCEDURE .

   No  : Go to  3.

3. CHECK DOOR INDICATOR  .

   Using the Subaru Select Monitor, check the following items in the [Active Test] of [Combination Meter]. Ref. to COMBINATION METER (DIAGNOSTICS)>ACTIVE TEST .

   • All seats door
   • Driver side door
   • Passenger side door
   • Rear side (right) door
   • Rear side (left) door

   Do the indication on Subaru Select Monitor and the door indicator indication match?

   Yes  : Go to  4.

   No  : Replace the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER .

4. CHECK DATA MONITOR FOR BODY INTEGRATED UNIT  .

   Using the Subaru Select Monitor, check the following items in the [Data Monitor] of [Body Control]. Ref. to BODY CONTROL (DIAGNOSTICS)>DATA MONITOR .

   • Driver's door SW input
   • P-door SW input
   • Rear right door SW input
   • Rear left door SW input

   Do the door open/close and data indication match?

   Yes  : Replace the body integrated unit. Ref. to SECURITY AND LOCKS>BODY INTEGRATED UNIT .

   No  : Inspect door switch circuit. Ref. to SECURITY AND LOCKS>KEYLESS ENTRY SYSTEM>INSPECTION .