Cruise Control Indicator Does Not Illuminate
WARNING: This page is about a different variant/trim than selected.
Trouble causes:
- CAN communication failure
- Combination meter malfunction
- Cruise control command switch circuit malfunction
CAUTION:
Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to LAN SYSTEM (DIAGNOSTICS) (HEV)>GENERAL DESCRIPTION>CAUTION .
- CHECK DTC
.
- Start the engine.
- Using the Subaru Select Monitor, read all DTCs. Ref. to LAN SYSTEM (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .
Is DTC U**** displayed? (Current malfunction)
Yes : Perform the diagnosis according to the basic diagnostic procedure in LAN SYSTEM (DIAGNOSTICS). Ref. to LAN SYSTEM (DIAGNOSTICS) (HEV)>BASIC DIAGNOSTIC PROCEDURE .
No : Go to 2.
- CHECK DATA MONITOR OF ENGINE
.
Using the Subaru Select Monitor, check the following items in the [Data Monitor] of [Engine]. Ref. to ENGINE (DIAGNOSTICS) (H4DO (HEV))>DATA MONITOR .
- Main Switch
Do the switch operation and data indication match?
Yes : Replace the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER .
No : Check the cruise control command switch. Ref. to CRUISE CONTROL SYSTEM>CRUISE CONTROL COMMAND SWITCH .