[S], [I] Or [S#] Indicator Is Blinking

Trouble causes: 

• CAN communication failure
• ECM failure
• Combination meter malfunction

1. CHECK DTC  .

   Using the Subaru Select Monitor, read the DTCs of [Engine] and [Combination Meter]. Ref. to ENGINE (DIAGNOSTICS) (H4DO (HEV))>DIAGNOSTIC TROUBLE CODE (DTC) . Ref. to COMBINATION METER (DIAGNOSTICS)>Diagnostic Trouble Code (DTC) .

   • Engine
   • Combination Meter

   Are any DTCs displayed? (Current malfunction)

   Yes  : Perform the diagnosis for the displayed DTCs.

   No  : Go to  2.

2. CHECK DTC  .
   1. Start the engine.
   2. Using the Subaru Select Monitor, read all DTCs. Ref. to LAN SYSTEM (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .

   Is DTC U**** displayed? (Current malfunction)

   Yes  : Perform the diagnosis according to the basic diagnostic procedure in LAN SYSTEM (DIAGNOSTICS). Ref. to LAN SYSTEM (DIAGNOSTICS) (HEV)>BASIC DIAGNOSTIC PROCEDURE .

   No  : Go to  3.

3. CHECK THE ENGINE COOLANT TEMPERATURE LIGHT  .

   Using the Subaru Select Monitor, check the following items in the [Active Test] of [Combination Meter]. Ref. to COMBINATION METER (DIAGNOSTICS)>ACTIVE TEST .

   • [S]indicator
   • [I]indicator
   • [S#]indicator

   Do the indicated amount on Subaru Select Monitor and the SI-DRIVE indication match?

   Yes  : Check the engine. Ref. to ENGINE (DIAGNOSTICS) (H4DO (HEV))>BASIC DIAGNOSTIC PROCEDURE .

   No  : Replace the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER .