Related Lines, More Than 52 Ω And Less Than 62 Ω (Main-Can_Steering Angle Sensor)

Wiring diagram: 

CAN communication system Ref. to WIRING SYSTEM (CROSSTREK MODEL (HEV))>CAN COMMUNICATION SYSTEM>WIRING DIAGRAM .

Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.

1. CHECK BETWEEN RELATED LINES AND MAIN WIRING HARNESS  .
   1. Disconnect the steering angle sensor connector.
   2. Using a tester, measure the resistance between terminals of steering angle sensor connector.

      Connector & terminal 

      (i74) No. 2 - (i74) No. 3:

   Is the resistance 400 Ω or more?

   Yes  : A related line between steering angle sensor and main wiring harness is open, or main wiring harness is open at two places or more.

   No  : Go to  2.

2. CHECK RELATED LINES  .
   1. Disconnect the central gateway Control Module connector.
   2. Using a tester, measure the resistance between the steering angle sensor connector and central gateway Control Module.

      Connector & terminal 

      (i74) No. 2 - (i366) No. 7:

      (i74) No. 3 - (i366) No. 22:

   Is the resistance 10 Ω or more?

   Yes  : Repair or replace the open circuit of steering angle sensor related lines.

   No  : Check DTC of VDC. Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .