Related Lines, More Than 52 Ω And Less Than 62 Ω (Main-Can_AWD)

WARNING: This page is about a different variant/trim than selected.

Wiring diagram:

CAN communication system Ref. to WIRING SYSTEM (CROSSTREK MODEL (HEV))>CAN COMMUNICATION SYSTEM>WIRING DIAGRAM .

G13246093

Courtesy of SUBARU OF AMERICA, INC.

G13246094

Courtesy of SUBARU OF AMERICA, INC.

NOTE: Perform inspection when no data is received, or faulty is detected. This is different from power supply shorted or ground shorted.

CHECK BETWEEN RELATED LINES AND MAIN WIRING HARNESS .
1. Disconnect the AWD Control Module connector.
2. Using a tester, measure the resistance between terminals of AWD Control Module connector.
  Connector & terminal
  
  (B648) No. 1 - (B648) No. 14:
Is the resistance 400 Ω or more?

Yes : A related line between AWD Control Module and main wiring harness is open, or main wiring harness is open at two places or more.

No : Go to 2.
CHECK RELATED LINES .
1. Disconnect the steering sensor connector.
2. Using a tester, measure the resistance between AWD Control Module connector and steering sensor connector.
  Connector & terminal
  
  (B648) No. 1 - (i74) No. 3:
  
  (B648) No. 14 - (i74) No. 2:
Is the resistance 10 Ω or more?

Yes : Repair or replace the open circuit of AWD Control Module related lines.

No : Check DTC of AWD Control Module. Ref. to AWD CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .