Related Lines, More Than 52 Ω And Less Than 62 Ω (Body-Can Telematics)
WARNING: This page is about a different variant/trim than selected.
Wiring diagram:
CAN communication system Ref. to WIRING SYSTEM (CROSSTREK MODEL (HEV))>CAN COMMUNICATION SYSTEM>WIRING DIAGRAM .
- CHECK BETWEEN RELATED LINES AND MAIN WIRING HARNESS
.
- Disconnect the DCM connector.
- Using a tester, measure the resistance between terminals in DCM connector.
Connector & terminal
(i270) No. 6 - (i270) No. 16:
Is the resistance 400 Ω or more?
Yes : A related line between DCM and main wiring harness is open, or main wiring harness is open at two places or more.
No : Go to 2.
- CHECK RELATED LINES
.
Using a tester, measure the resistance between DCM connector and audio or navigation unit connector.
Connector & terminal
(i270) No. 6 - (i87) No. 9:
(i270) No. 16 - (i87) No. 10:
Is the resistance 10 Ω or more?
Yes : Repair or replace the open circuit of telematics system related lines.
No : Check DTC of the telematics. Ref. to TELEMATICS SYSTEM (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .