Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the Crosstrek Base, Automatic CVT Trans, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All | 1.8 | B | ||
| Front or Rear,Both Sides | 1.0 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: Includes: Bleed System. | ||||
| Each Additional | 0.2 | B | ||
| One | 0.7 | B | ||
| Combination Procedure: BRAKE SYSTEM: Bleed: NOTE: This operation is not to be used with any other operation(s) containing brake fluid bleed. | ||||
| 0.6 | B | |||
| Combination Procedure: CALIPER: Replace: | ||||
| One | Includes: Bleed Brakes. | 0.7 | B | |
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Correct: | ||||
| Lateral Runout,Each | Correct Rotor lateral runout by indexing or correction plate. | 0.2 | B | |
| Combination Procedure: DISC ROTOR: Remove & Install or Remove & Replace: | ||||
| Each | 0.1 | B | ||
| Combination Procedure: DISC ROTOR (REMOVED): Refinish: DOES NOT include grind hot spots. | ||||
| Each Additional | 0.3 | B | ||
| One | 0.5 | B | ||
| Combination Procedure: ELECTRONIC PARKING BRAKE SYSTEM: Disable & Enable: | ||||
| Maintenance Mode | Includes: Disable and enable electronic brake system with use of scan tool or interactive vehicle controls. | 0.2 | B | |
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | B | |
| Combination Procedure: PARKING BRAKE SHOE & LINING: Replace: | ||||
| Each Side | 0.4 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| Front,One | 0.3 | B | ||
| Rear,One | 0.4 | B | ||