LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (CVT Transaxle (Th2A)) >> Inhibitor Switch >> Inspection >> Inhibitor Switch Signal Circuit

Inhibitor Switch Signal Circuit

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO (EXCEPT FOR HEV))>AIR INTAKE BOOT>REMOVAL .
  3. Disconnect the inhibitor harness connector.
  4. Check the inhibitor switch signal circuit.
    1. Check the circuit of each range.
      NOTE: If faulty, check the inhibitor harness for open circuit or short circuit, or poor contact.
      G13233202Courtesy of SUBARU OF AMERICA, INC.
      Terminal No. Inspection conditions Standard
      3 - 5 P range Less than 1 Ω
      3 - 6
      3 - 11
      3 - 1 R range
      3 - 6
      3 - 11 N range
      3 - 19
      3 - 15 D range
      3 - 18
      3 - 11 B range
      3 - 15
      3 - 18
scientia non olet · About LEMON Manuals