LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Manual Transaxle & Differential (6MT)) >> Transfer Driven Gear >> Installation

Transfer Driven Gear: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the taper roller bearing (transfer case side) outer race.
    G13604596Courtesy of SUBARU OF AMERICA, INC.
  2. Apply a coat of grease to the taper roller bearing (transfer case side) of transfer driven gear and the roller rolling surface of the taper roller bearing (extension case side).

    Grease: 

    NICHIMOLY N-130 or equivalent

  3. Install the transfer driven gear and center differential as a unit.
    G13233734Courtesy of SUBARU OF AMERICA, INC.
  4. Select the adjusting washer. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>TRANSFER CASE AND EXTENSION CASE ASSEMBLY>INSTALLATION .
  5. Install the selected adjusting washer and taper roller bearing (extension case side) outer race to the extension case.
  6. Install the transfer case and the extension case assembly. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>TRANSFER CASE AND EXTENSION CASE ASSEMBLY>INSTALLATION .
  7. Install the back-up light switch and the neutral position switch. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>SWITCHES AND HARNESS>INSTALLATION .
  8. Install the manual transmission assembly to the vehicle. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>MANUAL TRANSMISSION ASSEMBLY>INSTALLATION .
scientia non olet · About LEMON Manuals