LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Manual Transaxle & Differential (6MT)) >> Front Differential Assembly >> Installation

Front Differential Assembly: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the differential side retainers using the ST (WRENCH COMPL RETAINER).
  2. Install the taper roller bearing outer race to the transmission case.
  3. Install the front differential assembly.
    CAUTION: Make sure the oil seal lip is not folded.
    G10323013Courtesy of SUBARU OF AMERICA, INC.
  4. Install the main shaft assembly. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>MAIN SHAFT ASSEMBLY>INSTALLATION .
  5. Install the drive pinion shaft assembly. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>DRIVE PINION SHAFT ASSEMBLY>INSTALLATION .
  6. Install the transmission case. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>TRANSMISSION CASE>INSTALLATION .
  7. Install the transfer case together with the extension case assembly. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>TRANSFER CASE AND EXTENSION CASE ASSEMBLY>INSTALLATION .
  8. Install the manual transmission assembly to the vehicle. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>MANUAL TRANSMISSION ASSEMBLY>INSTALLATION .
scientia non olet · About LEMON Manuals