Differential Side Retainer
WARNING: This page is about a different variant/trim than selected.
- Using the ST, install a new oil seal by lightly tapping with a plastic hammer.CAUTION:
- Apply transmission gear oil to the oil seal lips, and install the oil seal while being careful not to deform the lip.
- Check the identification marks (L, R), and attach the oil seals RH and LH.
Preparation tool:
ST: DIFFERENTIAL SIDE OIL SEAL INSTALLER (18675AA000)
- Install a new O-ring.NOTE:
- Apply transmission gear oil to O-ring.
- Do not stretch or damage the O-ring.
- Install the O-ring after adjusting the hypoid driven gear backlash and completing the tooth contact inspection.