Differential Bevel Pinion Gear Backlash
WARNING: This page is about a different variant/trim than selected.
- Disassemble the front differential assembly. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>FRONT DIFFERENTIAL ASSEMBLY>DISASSEMBLY .
- Select the adjusting washer from the table and install.
Adjusting washer Part No. Thickness mm (in) 803038021 0.925 - 0.950
(0.0364 - 0.0374)803038022 0.975 - 1.000
(0.0384 - 0.0394)803038023 1.025 - 1.050
(0.0404 - 0.0413) - Adjust until the standard value is obtained.
Specification:
0.13 - 0.18 mm (0.0051 - 0.0071 in)