Switches And Harness: Removal: Switch

WARNING: This page is about a different variant/trim than selected.

TIMER CHARGING SETTING SWITCH

Disconnect the ground terminal from battery and wait for at least 60 seconds before starting work. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
Remove the cover assembly - instrument panel LWR driver OUT. Refer to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>REMOVAL .

Remove the timer charging setting switch.

Release the claws and remove the timer charging setting switch (b).

Courtesy of SUBARU OF AMERICA, INC.

HYBRID MODE SWITCH

Disconnect the ground terminal from battery. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
NOTE: Release the shift lock and shift the select lever to the "N" position. Refer to CONTROL SYSTEMS>SELECT LEVER>REMOVAL .
Remove the cover assembly - front. Refer to EXTERIOR/INTERIOR TRIM>CONSOLE BOX>REMOVAL .

Remove the hybrid mode switch.

Release the claws and remove the hybrid mode switch.

Courtesy of SUBARU OF AMERICA, INC.