General Tool
WARNING: This page is about a different variant/trim than selected.
| TOOL NAME | REMARKS | |
|---|---|---|
| Insulated gloves | Used for removing/installing and inspecting high voltage components. | |
| Goggles | ||
| Rubber boots for electrical purposes, insulated protective shoes or insulating mat | ||
| Insulating sheet | ||
| Insulated tools | Insulated 10-mm socket | |
| Insulated extension | ||
| Insulated ratchet handle | ||
| Insulated torque wrench | ||
| Insulated flat tip screwdriver | ||
| Insulated spanner 10 mm (Bahco, model No: 6MV-10) | ||
| Mini crane | Used for removing and installing the HV battery and performing the discharge procedure by means of salt water immersion. | |
| Front cable (Diameter approximately 8 mm (0.31 in) x Length approximately 2, 100 mm (6.89 ft)) |
Used to remove and install the HV battery. | |
| Rear cable (Diameter approximately 8 mm (0.31 in) x Length approximately 2, 380 mm (7.81 ft)) |
||
| Guide wire (Diameter approximately 4 mm (0.16 in) x Length approximately 3, 000 mm (9.84 ft)) |
||
| Protective rubber (Cut and use the pressure-resistant hose.) (Diameter (outer diameter) approximately 18 mm (0.31 in), diameter (inner diameter:) approximately 10 mm (0.31 in) x length approximately 50 mm (1.97 in)) |
||
| Carabiner | Used for performing the HV battery discharge procedure by means of salt water immersion. | |
| Cable (Diameter approximately 8 mm (0.31 in) x Length approximately 1, 500 mm (4.92 ft)) | ||
| Wire rope or chain sling (Approx. 800 mm (2.62 ft) in length) |
||
| Insulating tape | Used in the high voltage system and terminals and connectors. | |
| Circuit tester | Used for measuring resistance, voltage and current. | |
| DST-i | Used together with Subaru Select Monitor 4. | |