LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (OEM Wiring Diagrams W/ Connector End Views & Fuse/Relay Locations (HEV)) >> Working Precautions >> Precautions When Working With The Parts Mounted On The Vehicle

Precautions When Working With The Parts Mounted On The Vehicle

WARNING: This page is about a different variant/trim than selected.
  1. Always refer to "CAUTION" and "NOTE" of "General Description" in the same model's service information before starting the service.
  2. When working under a vehicle which is jacked-up, always be sure to use rigid rack.
  3. The parking brake must always be applied during working. Also, in automatic transmission vehicles, keep the select lever set to the P (Parking) range.
  4. Be sure the workshop is properly ventilated when running the engine.
  5. Be careful not to touch the rotating parts such as a belt or a fan while the engine is operating.
  6. Be careful not to touch hot metal parts immediately after the engine has been turned on or off.
scientia non olet · About LEMON Manuals