Freeze Frame Data: List
WARNING: This page is about a different variant/trim than selected.
| Item | Contents | Standard/Unit | Note |
|---|---|---|---|
| In-vehicle Sensor Temperature | Display the in-vehicle sensor value. | -72.47 - 193.82°C | - |
| Refrigerant Pressure | Display the pressure sensor value. | 0 - 3.29 Mpa | - |
| Quantity of Sunload | Display the sunload sensor value. | 0 - 4448 W/m2 | - |
| Heater Water Temperature | Display the engine coolant temperature. (CAN information) | -40.00 - 214 °C | - |
| Heater Control Panel Setting Value (Driver's) | Display the set temperature of the A/C control panel on driver's seat side. | 15 - 90 | - |
| Blower outlet request temperature (Driver's) | Display the inner set value of the A/C control panel. | -327.68 - 327.67°C | - |
| Air mix door actuator position (driver's side) | Display the driver's seat air mix door actuator position information. | -32.68 - 133.33 % | - |
| Mode Door Actuator Position | Display the mode door actuator position information. | -32.68 - 133.33 % | - |
| Fresh/Recircle Air Door Actuator Position | Display the intake door actuator position information. | -32.68 - 133.33 % | - |
| Target air mix door actuator position (driver's side) | Display the driver's seat air mix door actuator target position information. | -32.68 - 133.33 % | - |
| Mode Door Actuator Position Target | Display the mode door actuator target position information. | -32.68 - 133.33 % | - |
| Fresh/Recircle Air Door Actuator Position Target | Display the intake door actuator target position information. | -32.68 - 133.33 % | - |
| Blower Fan Level | Display the blower fan motor speed level. | 0 - 255 | - |
| Ambient Air Temperature | Display the ambient sensor value. (CAN information) | -40 - 80 °C | - |
| Compressor operation status | Display the operation status of the compressor. | OFF/ON | - |
| Blower Fan Operating Condition | Display the operation status of the blower fan. | MANU/AUTO | - |
| A/C Operating Condition | Display the operation status of the compressor. | MANU/AUTO | - |
| Fresh/Recircle Air Operating Condition | Display the operation status of the FRESH/RECIRC. | MANU/AUTO | - |
| Mode Operating Condition | Display the operation status of the blow vents. | MANU/AUTO | - |
| Rear Defogger | Display the operation status of the rear defogger switch. | OFF/ON | - |
| Engine Speed | Display the engine speed. (CAN information) | 0 - 32767 rpm | - |
| Vehicle Speed | Display the vehicle speed. (CAN information) | 0 - 300 km/h | - |
| Evaporator Temperature | Display the evaporator sensor value. | -82.48 - 153.55°C | - |
| Evaporator Temperature Target | Display the evaporator target temperature. | 0 - 20 °C | - |
| Discharge Refrigerant Temperature | Discharged refrigerant temperature is displayed. | -40 - 214 °C | - |
| Inner Condenser Out Refrigerant Temperature | Interior condenser outlet refrigerant temperature is displayed. | -40 - 214 °C | - |
| External Condenser Out Refrigerant Temperature | Exterior condenser outlet refrigerant temperature is displayed. | -40 - 214 °C | - |
| Evaporator Out Refrigerant Temperature | Evaporator outlet refrigerant temperature is displayed. | -40 - 214 °C | - |
| High Pressure Solenoid Valve Drive State | Drive status of High pressure solenoid valve is displayed. | OFF/ON | - |
| Low Pressure Solenoid Valve Drive State | Drive status of Low pressure solenoid valve is displayed. | OFF/ON | - |
| Cooling Expansion Valve Drive State | Drive status of Cooling expansion valve is displayed. | 0 - 100% | - |
| Heating Expansion Valve Driving State | Drive status of Heating expansion valve is displayed. | 0 - 100% | - |
| Target Air Temperature Behind Inner Condenser | Target air temperature after the interior condenser is displayed. | -40 - 214 °C | - |
| Estimated Air Temperature Behind Inner Condenser | Estimated air temperature after the interior condenser is display. | -40 - 214 °C | - |
| Operation Cycle State | Drive cycle status is displayed. | 01: Cooling 02: Dehumid.(S) 03: Dehumid. (P) 04: Heating 05: Defrosting 06: Idol 07: Initialize |
- |
| Electric driven compressor target speed | Electric compressor ASSEMBLY target speed is displayed. | 0 - 32767 rpm | - |
| Blower outlet Door Request Temperature | Display the blow vents target temperature. | -327.68 - 327.67°C | - |
| PTC operation steps | Display the blow vents target temperature. | 0 - 3 | - |
| PTC Heater 1 | Display operation status of PTC 1st level. | Inoperative/Operate | - |
| PTC Heater 2 | Display operation status of PTC 2nd level. | Inoperative/Operate | - |
| PTC Heater 3 | Display operation status of PTC 3rd level. | Inoperative/Operate | - |
| Request engine speed | Display the request engine speed. | 0: Without Request
|
- |
| Heater core Temp. | Heater core sensor reading is displayed. | -40 - 214 °C | - |