LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (HVAC System (Diagnostics) (HEV)) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC B14E8: Heater Core Sensor Circuit Short-Circuit

DTC B14E8: Heater Core Sensor Circuit Short-Circuit

WARNING: This page is about a different variant/trim than selected.

DTC detecting condition: 

Heater core sensor circuit is shorted.

Trouble symptom: 

Proper outlet air temperature cannot be kept.

Wiring diagram: 

Air conditioning system Ref. to WIRING SYSTEM (CROSSTREK MODEL (HEV))>AIR CONDITIONING SYSTEM>WIRING DIAGRAM .

G13616452Courtesy of SUBARU OF AMERICA, INC.
CAUTION: Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to AIR CONDITIONER (DIAGNOSTICS) (HEV)>GENERAL DESCRIPTION>CAUTION .
  1. CHECK CONNECTOR  .
    1. Check connecting condition of the A/C control panel connector and heater core sensor connector.
    2. Turn the ignition switch to ON.
    3. Read the DTC of [Air Conditioner] using the Subaru Select Monitor. Ref. to AIR CONDITIONER (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .

    Is DTC B14E8 displayed? (Current malfunction)

    Yes  : Go to  2.

    No  : Even if DTC is displayed, the circuit has returned to a normal condition at this time.

    Reproduce the failure, and then perform the diagnosis again.

    NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
  2. CHECK HEATER CORE SENSOR  .
    1. Turn the ignition switch to OFF.
    2. Disconnect the heater core sensor. Ref. to AIR CONDITIONER (HEV)>HEATER CORE SENSOR .
    3. Turn the ignition switch to ON.
    4. Read the DTC of [Air Conditioner] using the Subaru Select Monitor. Ref. to AIR CONDITIONER (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .

    Is DTC B14E7 displayed? (Current malfunction)

    Yes  : Replace the heater core sensor. Ref. to AIR CONDITIONER (HEV)>HEATER CORE SENSOR .

    No  : Go to  3.

  3. CHECK HARNESS  .

    Using the tester, measure the voltage between terminals.

    Connector & terminal 

    (i293) No. 1 (+) - (i293) No. 2 (-):

    Is the voltage 4.5 - 5.5 V?

    Yes  : Check the connection of the heater core sensor circuit.

    No  : Go to  4.

  4. CHECK HARNESS (SHORTED BETWEEN LINES)  .
    1. Turn the ignition switch to OFF.
    2. Disconnect the connector from the A/C control panel.
    3. Using a tester, check continuity between terminals.

      Connector & terminal 

      (i293) No. 1 - (i293) No. 2:

    Is there continuity?

    Yes  : Repair or replace the short circuit of the harness.

    No  : Replace the A/C control panel. Ref. to AIR CONDITIONER (HEV)>CONTROL PANEL>REMOVAL .