LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (HVAC System (Diagnostics) (HEV)) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC B1439: Mode Door Actuator Circuit Short-Circuit

DTC B1439: Mode Door Actuator Circuit Short-Circuit

WARNING: This page is about a different variant/trim than selected.

DTC detecting condition: 

Mode door actuator potentiometer circuit is shorted.

Trouble symptom: 

Vent does not change.

Wiring diagram: 

Air conditioning system Ref. to WIRING SYSTEM (CROSSTREK MODEL (HEV))>AIR CONDITIONING SYSTEM>WIRING DIAGRAM .

G13245527Courtesy of SUBARU OF AMERICA, INC.
CAUTION: Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to AIR CONDITIONER (DIAGNOSTICS) (HEV)>GENERAL DESCRIPTION>CAUTION .
  1. CHECK CONNECTOR  .
    1. Check connecting condition of the A/C control panel connector and mode door actuator connector.
    2. Turn the ignition switch to ON.
    3. Read the DTC of [Air Conditioner] using the Subaru Select Monitor. Ref. to AIR CONDITIONER (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .

    Is DTC B1439 displayed? (Current malfunction)

    Yes  : Go to  2.

    No  : Even if DTC is displayed, the circuit has returned to a normal condition at this time.

    Reproduce the failure, and then perform the diagnosis again.

    NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
  2. CHECK ACTUATOR  .
    1. Turn the ignition switch to OFF.
    2. Disconnect the connector from the mode door actuator.
    3. Turn the ignition switch to ON.
    4. Read the DTC of [Air Conditioner] using the Subaru Select Monitor. Ref. to AIR CONDITIONER (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .

    Is DTC B1438 displayed? (Current malfunction)

    Yes  : Replace the mode door actuator. Ref. to AIR CONDITIONER (HEV)>MODE DOOR ACTUATOR .

    No  : Go to  3.

  3. CHECK HARNESS (SHORTED BETWEEN LINES AND SHORTED TO GROUND)  .
    1. Turn the ignition switch to OFF.
    2. Disconnect the connector from the A/C control panel.
    3. Using a tester, check the continuity between terminals in mode door actuator connector and between mode door actuator connector and chassis ground.

      Connector & terminal 

      (i176) No. 2 - (i176) No. 1:

      (i176) No. 2 - Chassis ground:

    Is there continuity?

    Yes  : Repair or replace the short circuit of the harness.

    No  : Replace the A/C control panel. Ref. to AIR CONDITIONER (HEV)>CONTROL PANEL .