Section 25 (HVAC System (Diagnostics) (HEV)): Customize: List
WARNING: This page is about a different variant/trim than selected.
| Item | Initial setting value | Setting value | Note |
|---|---|---|---|
| Fresh/Recircle Air Door Auto Mode | AUTO | AUTO | When AUTO mode is actuated, inlet switching is also automatically operated. |
| MANU | Even when AUTO mode is actuated, inlet switching is not automatically operated. (Switching can only be manually operated) | ||
| Compressor auto mode | AUTO | AUTO | When AUTO mode is actuated, compressor is also automatically operated. |
| MANU | Even when AUTO mode is actuated, compressor is not automatically operated. (Switching can only be manually operated) | ||
| Setting temperature shift | 0 | -3 | Adjust the A/C target value relative to the set temperature. |
| -2 | |||
| -1 | |||
| 0 | |||
| +1 | |||
| +2 | |||
| +3 | |||
| Mode/VENT II | Yes | Yes | When AUTO mode is operated, VENT II mode (upper wind: large, lower wind: small) is present. |
| No | When AUTO mode is operated, VENT II mode (upper wind: large, lower wind: small) is absent. | ||
| Mode/All Flow | Yes | Yes | When AUTO mode is operated, all-flow mode (wind comes from all blower vents) is present. |
| No | When AUTO mode is operated, all-flow mode (wind comes from all blower vents) is absent. | ||
| Mode/HEAT III | Yes | Yes | When AUTO mode is operated, HEAT III mode (footwell/DEF ratio is different) is present. |
| No | When AUTO mode is operated, HEAT III mode (footwell/DEF ratio is different) is absent. | ||
| Release Max A/C by Mode Sw | Yes | Yes | When the mode dial is operated in MAX A/C status, MAX A/C status is deactivated. |
| No | Even when the mode dial is operated in MAX A/C status, MAX A/C status is not deactivated. |