DTC P0500: Vehicle Speed Sensor "A" Circuit: Notes
WARNING: This page is about a different variant/trim than selected.
1. -
DTC detecting condition:
Immediately at fault recognition
NOTE:
After the faulty parts are repaired or replaced, perform the final check in Basic Diagnostic Procedure. Ref. to ENGINE (DIAGNOSTICS) (H4DO (HEV))>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE
.
- CHECK DTC OF VDC
.
- Turn the ignition switch to ON.
- Using the Subaru Select Monitor or a general scan tool, read the DTC of [VDC]. Ref. to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC)
.
Is DTC for [VDC] displayed? (Current malfunction)
Yes: Check the appropriate DTC using the "Diagnostic Trouble Code (DTC)". Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .
No: Repair the poor contact of ECM connector.