LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Emission Control Systems (Aux. Emission Control Devices) (HEV)) >> EGR Temperature Sensor >> Installation

EGR Temperature Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION: Always use a new EGR temperature sensor.
  1. Temporarily tighten the EGR temperature sensor by hand until the sensor is seated.
  2. Tighten the EGR temperature sensor then connect the connector.

    Tightening torque: 

    45 N.m (4.6 kgf-m, 33.2 ft-lb)

  3. Install the air intake duct. Ref. to INTAKE (INDUCTION) (H4DO (EXCEPT FOR HEV))>AIR INTAKE DUCT>INSTALLATION .
  4. Connect the battery ground terminal. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals