DTC P2007: TGV Control Stuck Closed Bank 2: Notes
WARNING: This page is about a different variant/trim than selected.
- -
DTC detecting condition:
Immediately at fault recognition
NOTE: After the faulty parts are repaired or replaced, perform the final check in Basic Diagnostic Procedure. Ref. to ENGINE (DIAGNOSTICS) (H4DO (HEV))>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .
- CHECK DTC
.
Using the Subaru Select Monitor or a general scan tool, read the DTC of [Engine]. Ref. to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .
Is DTC other than P2007 displayed? (Current malfunction)
Yes: Check the appropriate DTC using the "Diagnostic Trouble Code (DTC)". Ref. to ENGINE (DIAGNOSTICS) (H4DO (HEV))>DIAGNOSTIC TROUBLE CODE (DTC) .
No: Go to 2.
- CHECK TUMBLE GENERATOR VALVE LH
.
- Remove the intake manifold assembly. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO (HEV))>INTAKE MANIFOLD ASSEMBLY>REMOVAL .
- Check the tumble generator valve.
Is there any dirt or clogging with foreign objects in the tumble generator valve?
Yes: Clean the tumble generator valve.
No: Replace the tumble generator valve LH. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO (HEV))>TUMBLE GENERATOR VALVE .
NOTE: The tumble generator valve cannot be disassembled.