LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (M/T Clutch System) >> Clutch Switch >> Installation >> Clutch Start Switch

Clutch Start Switch

WARNING: This page is about a different variant/trim than selected.
  1. Install the clutch start switch.
  2. Fully depress the clutch pedal and hold it.
  3. Install so that the gap (A) between the clutch pedal plate and the clutch start switch becomes 7.3 mm (0.29 in), and tighten the lock nut.

    Tightening torque: 

    8 N.m (0.8 kgf-m, 5.9 ft-lb)

    G13604893Courtesy of SUBARU OF AMERICA, INC.
  4. Connect the connector to the clutch start switch.
  5. Check the clutch start system.
  6. Install the knee airbag module. Ref. to AIRBAG SYSTEM>KNEE AIRBAG MODULE>INSTALLATION .
  7. Install the instrument panel lower cover. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>INSTALLATION .
  8. Connect the ground terminal to 12V engine restart battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals