Real-time Diagnosis: Operation

WARNING: This page is about a different variant/trim than selected.

On [Start] screen, select [Diagnosis].
On [Vehicle selection] screen, input the target vehicle information and select [OK].
On [Main Menu] screen, select [Each System].
On [Select System] screen, select [EyeSight], and then select [Enter].
On [Select Function] screen, select [Data Monitor].
Check that the display changes and the contents are correct when performing the operations as follows.
If they are not displayed properly, check the following items.
- Depress and release the brake pedal. (Stop light switch and brake switch are turned ON.)
  - Item [Brake Lamp SW (BIU)] [Brake Lamp SW (VDC)]
- Turn the cruise switch to ON.
  - Item [Cruise Control SW Voltage (Port14)] [Cruise Control SW Voltage (Port16)]
- Turn the "SET/-" switch to ON.
  - Item [Cruise Control SW Voltage (Port14)] [Cruise Control SW Voltage (Port16)]
- Turn the "RES/+" switch to ON.
  - Item [Cruise Control SW Voltage (Port14)] [Cruise Control SW Voltage (Port16)]
- Turn the "F.D. Set +" switch to ON.
  - Item [Cruise Control SW Voltage (Port14)] [Cruise Control SW Voltage (Port16)]
- Turn the "Following distance -" switch to ON.
  - Item [Cruise Control SW Voltage (Port14)] [Cruise Control SW Voltage (Port16)]
- Turn the "Lane keep" switch to ON.
  - Item [Cruise Control SW Voltage (Port14)] [Cruise Control SW Voltage (Port16)]
- Operate the shift lever.
  - Item [Current gear position]
- Press and hold the pre-collision brake OFF switch.
  - Item [Pre-Collision Brake OFF Indicator]
- Press and hold the lane departure warning OFF switch.
  - Item [Lane Departure Warning OFF Indicator]
- Open/close the front and rear doors.
  - Item [Driver Door Status] [Passenger Door Front Status] [Right Rear Door Status] [Left Rear Door Status]
- Unbuckle and buckle the driver's seat belt.
  - Item [Driver Seat Belt Status]
  NOTE: For detailed operation procedures, refer to "Help" of application.