Circuit Explanation
WARNING: This page is about a different variant/trim than selected.
The Charge control ECU that is installed inside the Electric vehicle charger assembly uses the sub DCDC converter temperature sensor to monitor the DCDC converter temperature. DTC is output when an error in the sub DCDC converter temperature sensor is detected. If this DTC was detected, replace the Electric vehicle charger assembly.
For an explanation of the circuit, refer to DTC P1CCD96. Ref. to PLUG-IN BATTERY CHARGER (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC P1CCD96 SUB DC/DC CONVERTER (FOR CHARGING) COMPONENT INTERNAL FAILURE .