LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Plug-In Battery Charger (Diagnostics)) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P1C10-28: Current Sensor After Boosting By PFC Boosting Circuit Signal Bias Level Out Of Range/Zero Adjustment Failure >> General Description >> Circuit Explanation

Circuit Explanation

WARNING: This page is about a different variant/trim than selected.

The Charge control ECU installed inside the Electric vehicle charger assembly uses a IVH sensor to monitor the DC section current. It outputs a DTC code when an IVH sensor error is detected. If this DTC was detected, replace the Electric vehicle charger assembly.