Circuit Explanation
WARNING: This page is about a different variant/trim than selected.
The Charge control ECU installed inside the Electric vehicle charger assembly uses a VHT sensor to monitor the boost circuit temperature. It outputs a DTC code when a VHT sensor error is detected. If this DTC was detected, replace the Electric vehicle charger assembly.
For an explanation of the circuit, refer to DTC P0D3812. Ref. to PLUG-IN BATTERY CHARGER (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC P0D3812 HYBRID/EV BATTERY CHARGER INPUT CURRENT SENSOR CIRCUIT CIRCUIT SHORT TO AUXILIARY BATTERY .