DTC P0D38-9E: Hybrid/EV Battery Charger Input Current Sensor OVERCURRENT Detection Circuit Stuck On: Notes

WARNING: This page is about a different variant/trim than selected.

Outline of diagnosis:

Charger input overcurrent detection circuit became stuck in ON state.

(1 trip detection logic)

Trouble symptom:

Plug-in charging suspended

NOTE: This DTC is output when the Electric vehicle charger assembly detects an abnormality in the internal operation conditions.
Therefore if this DTC was detected, replace the Electric vehicle charger assembly. Ref. to HYBRID ELECTRIC VEHICLE>ELECTRIC VEHICLE CHARGER .